Recent content by ehall

I bought the Teraflex high-steer knuckle for my front D44 (I do not want WJ knuckles--nothing wrong with that, but I am going a different place). I am trying to layout the steering links. Right now the upper arm runs smack into the swaybar link hardware that I put in for OTK tie rod. So those...

I'm planning to replace the timing chain on my pos in a couple of weeks and looking for tips. The last time I did this (years ago) the motor was on a stand, this time doing it while the motor is still installed. Do I need to pull the radiator? Anything special about the gap between the timing...

Thinking about switching the (unofficial) FB group to private. Downside to being a public group is everybody sees what you post (notified in some cases), which limits participation a bit. The group was created as public so that events could be shared, but if the events are created on the...

Are the drawing results posted anywhere?

Anybody here have wiring diagrams for 97+ and willing to look up wire colors for the rear wiper and washer circuits? Neither of mine work, switch is putting voltage through the fuse, want to check the wires in the cargo panel that's already off before diving into the motor

I picked up another XJ recently, plan to use it for backup DD / winter driver. I am trying to get some stuff fixed so I can take it through MD inspection. The big thing is the ABS light is always on. I borrowed a friend's Snap-On MT2500 with a universal cartridge (he's a Ford master tech) and...

Looking to replace the ignition key cylinder in my steering column (worn out--key falls out on big bumps) and looking for experience / options. Can a locksmith cut a new cylinder to match my old key? Otherwise I would have to replace the door and hatch locks as well. Its a 91 don't think its in...

I was looking for new R12 service valves to go on a new replacement compressor. Couldn't find anything anywhere. Got to talking to a 4 Seasons tech and we went through the catalog, lo there they are Four Seasons parts 12721 and 12722 Available on Amazon pretty cheap as of right now

Looking to do a winter NAC run to Rausch or AOAA in late February. The weekend of Fri 23 through Sun 25 is best for me. Thoughts?

Other chapters have active groups, why don't we have a group? We have a feed that is never used. What's up

Gotta save some pennies for my next $$ upgrade and I can't quite decide between these three so I will ask the NAXJA family Long arm upgrade -- I'm on 6" of lift with short arms. Doesn't bother me except downtravel is limited by the rotational arc. I get a tire off the ground all the time and my...

blowing up Facebook today https://www.facebook.com/rockcrawlingisnotacrime/videos/1724476134238937/

I have a 91 but my HVAC system is bits and pieces of custom parts. I currently have it drained for a heater core swap. I was looking at ways to simplify it a bit and came across this page in the parts catalog. full size Is that an accurate diagram for 96? Earlier models all had service...

My 91 parts catalog shows the heater core / evap core foam seal as part number 56006312. I can't find this anywhere. The 01 parts catalog shows a multi-part seal "kit" part number 4874069AB which seems to be in production and available. Are they interchangeable?

Anybody have a meat thermometer they can stick in the radiator near the outlet to the water pump? What temperature are you seeing after engine has warmed up? and what is the ambient temperature? I have radiator inlet temp of 240 max dropping down to 100 at the outlet, so radiator is shedding...