Search results

  1. 4

    Drive shaft too short

    After installing new shims my rear cardan shaft is too short. I'm going to go out on a limb and guess no, but is worth/safe trying to cut the driveshaft down myself, or is this a dangerous balancing nightmare waiting to happen? Local shop is quoting me 190$ to cut and rebalance
  2. 4

    RE 3.5 leaf pin for shim

    Starting to get some Vibes need to install shims. I contacted Rubicon Express. They say 7/16 pin is what I need. Does this sound right, I've read different? And does anybody know if there is a torque spec for a leaf spring pin?
  3. 4

    wanted

    looking for someone in Noco that can scan SRS system with drbIII or equivalent scanner.
  4. 4

    choosing bolt sizes & strength for uca/lca

    Ive been digging through build variations If I was to do a DIY 3 link long arm. One focal point on my plate is the front d30 UCA mount which normally runs a 7/16 bolt. JJ makes an upgraded 1/2" bolt press in joint which is what I was thinking of adding. In my findings, some vendors kits use...
  5. 4

    clayton 3 link cross, diy arms/mount?

    figure Ill ask you guys before I find myself in a pickle. Ive been toying with a long arm for a while and thus far. Im kinda liking the idea of something like the Clayton 3 link crossmember and building my own arms for hopefully saving some coin, and something fun to do. the speedbump Im...
  6. 4

    99 auto airbag light/DRB?

    I've had a random off and on airbag light for quite some time now. The last time I had this issue I replaced my clockspring with a Dorman cruise control equipped unit, and the light went away. Currently my horn works and other than just the random airbaglight, there are no other symptoms common...
  7. 4

    1999 MOPAR cam position sensor/ pick up coil part#

    guys does mopar still make this part? does anyone have the part number available? thanks
  8. 4

    Busbars

    Looking to clean up the engine bay wiring a tad. I have military style battery clamps but I want to organize better with power and ground busbars & an alternator anl fuse holder. Thus far I assume the firewall area will be best for the bars, the ANL may need to be closer. I know there's not...
  9. 4

    Interior LED

    I just put in some led for fun on my 99. I have extra front and rear red dome light bulbs ( not map) and 5 blue gauge bulbs (LEDs) 10$
  10. 4

    Max is razr?

    Has anyone run these, they are an option for me? I'm on 33s ide like 35s but I don't think I can fit them without more lift/bump/trim on the flat flares. 33 Nittos currently fill the wheel wells substantially. Other options are nitto trail graps or mtr kevs, I've run both and really like both...
  11. 4

    Baker pass 10/8

    Planning baker pass with a friend tomorrow. Meeting at the gas station below the canyon 1130.
  12. 4

    99 xj stereo wiring

    Guys years ago my stereo was stolen after it was upgraded. There's a large ground wire going into the xj harness, but the stock stereo worked fine. I don't understand how this is possible? Wheres it grounded then lol? The new stereo has a large yellow wire intended for 12v battery direct/...
  13. 4

    Devils punchbowl

    A few obstacle here going down from CB. The trail has some seriously tight spots, Maybe 3 wheeling if not, deffinetly scrubbing some areas. Its sized for side by sides or such.
  14. 4

    ARB solenoid leaking oil

    Just recently my solenoid started leaking oil. I believe it might be diff oil, stinks a little. I haven't used my locker in ages so I find it out that there's oil leaking. I know they can leak when bad, but again it hasn't been used this year. I haven't check my breather tube yet, but I...
  15. 4

    4.7 stroker, whatchu got?

    I thought itd be fun to see what you all run these days, I'm curious if this is a common motor here. I suppose add anything you can think of worth sharing so far as running a stroker, but this is what I've thought to ask. -What are you getting for hp/tq and to the wheels if you know? .short or...
  16. 4

    Johnny joint spit snap ring out

    https://www.quadratec.com/products/16054_002.htm?gclid=CjwKCAjwzdLrBRBiEiwAEHrAYkXyFtIzdk2EE-FdGMlCdgczVA7FrAjfz4Yy1mSqI2cKRANXtltgDhoCQawQAvD_BwE I have a track bar with an end similar to this. I was under the jeep today and saw my washer dangling from the axle side. That's new lol I can't...
  17. 4

    Trans cooler upgrade?

    99 auto with country tow package. I'm curious if anyone knows of an after market trans cooler, that has the same clip on ends that the stock cooler has? These are the same clip fitting as the radiator trans cooling input. Thanks
  18. 4

    Alpine highway power ( od/passing gear)

    So I've recently been on some long journeys to southern CO mountains. I've done this trip many times in my 99 auto. Two different motors. Currently low end power is usual and everything is normal until climbing highway passes and it bogs to 40mph and doesn't want to hit overdrive/ passing gear...
  19. 4

    99 auto leak between tc/trans

    Way up in the hill and I'm guessing output seal is leaking between trans and tc. Need I worry other than keeping fluid level?
  20. 4

    99 airbag light

    99 auto airbag light on/off every few minutes more/less... Gauges work, horn works, dorman cruise equip clockspring replaced 1.5yr ago. No changes by wiggling wires behind ACM. Never have had a seatbelt light but something dies plug into the drivers seat. What All will cause this light...
Top