xjj33p3r NAXJA Member #1108 Aug 14, 2005 #1 I'm in the process of installing a lock rite, but I can't get the damn cross pin out so I can remove the cross shaft. Any ideas on what to use in order to hammer it out?
I'm in the process of installing a lock rite, but I can't get the damn cross pin out so I can remove the cross shaft. Any ideas on what to use in order to hammer it out?
HaleYes New member Aug 14, 2005 #2 You'll need to drive out the roll pin, if you didn't already know it. Should come right out after that. Roll pin is in the end of the crosspin. No need to double post. Your making members over #1107 look bad.:laugh3:
You'll need to drive out the roll pin, if you didn't already know it. Should come right out after that. Roll pin is in the end of the crosspin. No need to double post. Your making members over #1107 look bad.:laugh3:
